antenna load

antenna load
US <el> ■ Antennenbelastung f

English-german technical dictionary. 2013.

Игры ⚽ Поможем решить контрольную работу

Schlagen Sie auch in anderen Wörterbüchern nach:

  • Antenna measurement — techniques refers to the testing of antennas to ensure that the antenna meets specifications or simply to characterize it. Typical parameters of antennas are gain, radiation pattern, beamwidth, polarization, and impedance.The antenna pattern is… …   Wikipedia

  • load|ing — «LOH dihng», noun. 1. the act of a person or thing that loads: »Freight car loadings continue to slack off (Newsweek). 2. Electricity. the introduction of additional inductances, as to a telephone circuit or an antenna. 3. an addition to the net… …   Useful english dictionary

  • Antenna tuner — An antenna tuner, transmatch, or antenna tuning unit (ATU) matches a transceiver with a fixed impedance (typically 50 ohms for modern transceivers) to a load (feed line and antenna) impedance which is unknown, complex or otherwise does not match …   Wikipedia

  • Antenna (radio) — Whip antenna on car …   Wikipedia

  • Antenna analyzer — An antenna analyzer measuring SWR and complex impedance of a dummy load. MFJ Enterprises Inc. MFJ 269. An antenna analyzer (also known as a noise bridge, RX bridge, SWR analyzer, or RF analyzer) is a device used for measuring the efficiency of… …   Wikipedia

  • Antenna effective area — In telecommunication, antenna effective area or effective aperture is the functionally equivalent area from which an antenna directed toward the source of the received signal gathers or absorbs the energy of an incident electromagnetic wave. Note …   Wikipedia

  • Antenna aperture — As a receiver, antenna aperture can be visualised as the area of a circle constructed broadside to incoming radiation where all radiation passing within the circle is delivered by the antenna to a matched load. (Note that transmitting and… …   Wikipedia

  • Antenna factor — In telecommunications, the antenna factor AF (unit: 1/m) is defined as the ratio of the incident electromagnetic field strength E (units: V/m or µV/m) to the voltage V (units: V or µV) on the line connection of an antenna:: AF = frac EVIf all… …   Wikipedia

  • Dummy load — Cantenna dummy load suitable up to 30 MHz and up to 1 kW A dummy load is a device used to simulate an electrical load, usually for testing purposes. Contents 1 Radio …   Wikipedia

  • Metamaterial antenna — This Z antenna tested at the National Institute of Standards and Technology is smaller than a standard antenna with comparable properties. Its high efficiency is derived from the Z element inside the square that acts as a metamaterial, greatly… …   Wikipedia

  • Dipole antenna — A schematic of a half wave dipole antenna connected to an unbalanced coaxial cable. Better practice is to connect the balanced dipole to the unbalanced line with a balun. A dipole antenna is a radio antenna that can be made of a simple wire, with …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”